ETHERNET:
You will first need to make sure your unit is running at least Firmware to 60Aa05e at the oldest.
To apply the update you will need to download Right ARM from the link below.
https://www.hemispheregnss.com/firmware-software/
Using a serial cable to connect the unit, follow the instructions starting on page 11 of the user guide to apply the update.
Once complete, You can use any terminal program of your choosing, or you can download PocketMax from the link below.
https://www.hemispheregnss.com/firmware-software/
Once you have the serial cable connected to the unit, you can use your terminal program or terminal tab of PocketMax to issue commands.
There are two ways to get the IP address,
1) Connect the VS1000 to a network switch, and send the following commands over a serial port:
a. $JETHERNET,MODE,DHCP
b. $JETHERNET,PORTI,1000
c. $JETHERNET,WEBUI,ON
d. $JSAVE
Re-send the $JETHERNET command over the serial port. The response will have a dynamic IP address that you can use to connect to the Ethernet port as well as the Ethernet based WebUI.
Then power cycle the unit and lets try checking under the miscellaneous tab on the Web UI.
2) To enable Ethernet support with a statically assigned IP address, use the command
“$JETHERNET,MODE,STATIC,ip,subnet,”
where ip/subnet are each replaced with the relevant IP address.
An example command would be “$JETHERNET,MODE,STATIC,192.168.0.42,255.255.255.0”
To test this, use the command $JNETWORK,PING, to ping an address on the same subnet (192.168.0.xx)
-----------------------------------------------------------------------------------------------------------
WIFI:
If wifi has been Disabled, Use the command $JRELAY,PORTC,$JWIFI,MODE,ON
To query the setting, use the command $JRELAY,PORTC,$JWIFI and you will get the wifi configuration in reply, including the password.
To set the SSID and password manually, use the command $JRELAY,PORTC,$JWIFI,AP,[SSID],[PASSWORD]
To reset the SSID to default, $JRELAY,PORTC,$JWIFI,MODE,AP,AUTO,hgnss1234
If you are still having any issues please feel free to contact our support team and be sure to include the Serial Number of your unit and any logs you are having difficulty with as these will be requested by the support team, providing these with your ticket will help to expedite the process.
You can submit your ticket Here
Or at the Link Below.
https://hemispheregnss.zendesk.com/hc/en-us/requests/new